义乌义乌煤气灶维修检测漏气
点火器不产生火花：在使用时，发现打开煤气灶，但喷火器没有火喷出，属于故障情况。这是因为自然点火器的压电陶瓷正机不产生火花，使灶盘不能发火。故障主要是由自动开关接向压电陶瓷正极的导线因饶毁而断路，可重新用导线可靠连接。另外，如果压电陶瓷正极被沾污或锈蚀而造成接触不良，也会造成点火困难，这时可抽出金属圆棒，用细砂纸擦去污垢后再插入。、有火花但不能引燃：打开煤气灶，发现火花喷出，但不能引燃煤气，这也属于故障。原因在于压电陶瓷正极与灶盘负极间距离太远或太近，就会使火花不能引燃煤气，应把距离调整到4毫米左右。另外在近点火器一侧的燃气喷嘴被益出物或其他异物堵塞，也会造成点不着火或点火困难，这时只要清除喷嘴内的堵塞物即可。
The igniter does not produce sparks: when using, it is found that the gas stove is turned on, but the flamethrower does not emit fire, which is a fault condition. This is because the piezoelectric ceramic positive mechanism of the natural igniter does not produce sparks, so that the cooker cannot ignite. The main fault is that the wire connected to the positive pole of piezoelectric ceramic by the automatic switch is broken due to breakage, which can be reliably connected with the wire again. In addition, if the positive electrode of piezoelectric ceramic is contaminated or rusted, resulting in poor contact, it will also cause difficulty in ignition. At this time, pull out the metal round rod, wipe the dirt with fine abrasive paper, and then insert it Spark but can't ignite: open the gas stove and find that the spark is ejected, but can't ignite the gas, which is also a fault. The reason is that the distance between the positive electrode of the piezoelectric ceramic and the negative electrode of the cooker plate is too far or too close, which will make the spark unable to ignite the gas. The distance should be adjusted to about 4mm. In addition, the gas nozzle on the side near the igniter is blocked by outflow or other foreign matters, which will also cause ignition failure or ignition difficulty. At this time, it is only necessary to remove the blockage in the nozzle.